Some needs for large jaw crusher and problems

Some needs for large jaw crusher and problems

Shanghai : China | Jun 13, 2012 at 8:35 PM PDT
Views: Pending
Screen and Feeding machines of TEK-EL MAKINA trade company

At present, the jaw crusher has two most widely used structures: simple pendulum and compound pendulum. In the past, large mines always used the simple pendulum jaw crusher. But now, most of mines used the compound pendulum jaw crusher as the fist coarse crushing equipment. Both of them were belong to down moving type, the upper moving type has been eliminated for unreasonable structure.

The difference between simple pendulum and compound pendulum jaw crusher is: the compound type has less a hanging mandrel, a connecting rod and the bracket is only one. So the compound type structure is simple. But the movement is more complex than the simple pendulum type. It both has horizontal movement and vertical movement. It is a a complex movement. So it is also called complex-swing type jaw crusher.

Compared with simple pendulum jaw crusher, the compound pendulum jaw crusher has only one spindle. The gravity and crushing force are both concentrated on this spindle. So in a long time, the compound pendulum jaw crusher was made medium and small type. The main bearings also use rolling type. However, with the emergence of high-strength materials and large roller bearings, the compound pendulum jaw crusher is heading for the direction of larger-scale. The United States, Japan, Sweden and other countries had produced large-scale compound pendulum jaw crusher with the feeding size 1000-1500mm. China also produced 900mm×1200mm large-scale compound pendulum jaw crusher. Recently, Henan Hongxing Mining Machinery Co., LTD has launched 600mm×2200mm compound pendulum jaw crusher.

The crusher manufacturers at home and abroad had launched 1500 mm×2100 mm、1600 mm×2200 mm large compound pendulum jaw crusher. This jaw crusher has high capacity, lower power consumption, large crushing ratio and uniform size distribution, and has gradually replaced the simple pendulum jaw crusher. Many foreign famous manufacturers such as Mesto Minerals, the former A-C, Kobe Japan, Krupp Germany, Ceda U.S. had not produced the PJ simple pendulum jaw crusher. As the professional manufacturer of complete sets of mining machinery, such as jaw breakers, Henan Hongxing is always doing the best in products and service. raymond mill:
ball mills:

In process of replacing the bearing of large jaw crusher, we should pay attention to the following points:

1, what should we do when remove the old watt of jaw crusher:

(1) Measure the thickness of the old bush joint surface gasket.

(2) Measure the levelness of the spindle.

(3) Examine whether the spindle is smooth or not, and whether it with the defects of rust, bumps and so on or not. If the situation is exist, you should to eliminate it.

(4) Measure the of the bottom clearance, backlash and end clearance of the bearing bush.

2, Testing of the contact of the watt-back with the bearing of the jaw crusher. In order to prevent happening of the reverse sliding and rotating between the bearing bush and the bearing pedestal when the equipment operation, it generally adopts the pin, sleeve positioning mode.

3, The techniques requiring of the scraping the bearing bush Spindle scraping should meet the required standards of technical.

4, Scraping and grinding the spindle bush The scraping is generally divided into rough scraping, fine scraping and refined scraping three processes.

5, The measurement and the adjusting method of the bearing clearance.

hxmissyou is based in Zhengzhou, Henan, China, and is a Reporter on Allvoices.
Report Credibility
  • Clear
  • Share:
  • Share
  • Clear
  • Clear
  • Clear
  • Clear

More From Allvoices

Report Your News Got a similar story?
Add it to the network!

Or add related content to this report

Most Commented Reports

Use of this site is governed by our Terms of Use Agreement and Privacy Policy.

© Allvoices, Inc. 2008-2014. All rights reserved. Powered by PulsePoint.